Lead door has also become a ray radiation protection lead door, lead door is an indispensable radiology anti-radiation products, the installation of lead door is very important, if the installation is not correct will expose the line, so the lead door in the installation process must pay attention to a few points.

Precautions for installation of radiation-proof lead door:

1: Check the need to install the ray protective door, check whether the ray protective door and its switch are flexible and smooth.

2. Put the lead door door into the door hole (remove the door door if necessary, make the inner contact surface of the wrapping position fit the wall and vertical, and correct the surface plane of the wall if necessary.

3. Vertical positioning of the hinged side frame body must be done so that the point surface is on the same plane.

4. The hinge side frame is fixed, and the pull burst (M10 pull burst,∮ drill) is fixed or the pull sheet is fixed, which needs to be firm and lead door.

5, adjust the lock position of the wide body vertical position, so that the gap between the door and the door frame to achieve uniform position, and fixed.

6. Open the ray protective door and check whether the switch is flexible.

7, after the cement slurry or foam dry, remove the gap sheet and its backing plate can be.

8, the door body is made of national standard steel skeleton, stainless steel panel, lined with ray protection lead plate, combined with advanced cold high pressure bonding process. It is equipped with special stainless steel protective door shaft hinge, hardware, special engineering lock for imported protective door. With a variety of styles, a variety of specifications to choose from.